Programming a Honeywell Barcode Scanner

Setting up a Honeywell scanner on a PC is very easy - you plug them in, wait for the battery to charge if handheld, and start using it - no install required.

However, depending on the model, there may be some settings you need to change. Scanner settings are changed by scanning special programming barcodes.

When scanning a programming barcode, the scanner will make a different beep than normal.

These instructions are for Honeywell-brand scanners only. Do not follow these steps for other scanners.

Adding Carriage Return

Usually, when scanning a product into the POS screen the product will appear in the sale immediately. If instead when you scan a product the barcode number appears but nothing else happens, you will need to enable the Carriage Return Setting. To do this, follow these steps:

1. Download the document named 'Honeywell CR.pdf' from the bottom of this article.
   
2. Print out this PDF document.
   
3. Scan the barcode on the PDF
   

Once this is done, try scanning a product into the POS screen - the product should now immediately appear in the sale as normal.

Adding 2-digit Addenda for Magazines (Newsagencies Only)

Magazines use different barcodes from other products - they have an extra 2 digits at the end that denote what issue of the magazine it is. By default, scanners will not look for these extra digits - this feature needs to be turned on. To do so, follow these steps:

1. Download the document named 'Honeywell 2-digit Addenda.pdf' from the bottom of this article.
   
2. Print out this PDF document.
   
3. Scan all the barcodes on the PDF in order, they are numbered 1 through 8.

Resetting a Scanner back to Default Settings

Sometimes it may be necessary to reset a scanner back to its default settings - this can be because a mistake was made with other programming barcodes, or because the scanner is behaving erratically. To reset a scanner, follow these steps:

1. Download the document named 'Honeywell Reset.pdf' from the bottom of this article.
   
2. Print out this PDF document.
   
3. Scan the barcodes on the PDF in order, 1 then 2.

After resetting a scanner, it may be necessary to follow the steps to re-add the carriage return or 2-digit addenda again.

• Related Articles

• Programming an Element P303BT Barcode Scanner

  For our guide to pairing an Element P303BT scanner to a tablet, see HERE Setting up an Element scanner on a PC is easy - you plug in the cradle, sit the scanner on it and wait for the battery to charge, and then start using it - no install required. ...

• Programming a Zebra DS2278 Barcode Scanner

  Setting up a Zebra DS2278 scanner on a PC is very easy - you plug them in, wait for the battery to charge, and start using it - no install required. Before you get started with scanning though, there are some setting on the scanner you may need to ...

• Programming a Socket S700 Bluetooth Barcode Scanner

  For our guide to pairing your Socket S700 scanner to tablet, click HERE For the most part, once you have paired a Socket S700 scanner to your chosen device, it should be ready to go. The exception to this is for Newsagencies using to scan magazines - ...

• Pairing an Element Bluetooth Scanner for Roam

  The pairing steps shown below will only work with Element brand Scanners (Element P303). Setup Element scanner First, switch on the scanner by pressing the scanner button for 3 seconds. A light should indicate that it is on. Then, scan this QR code ...

• Pairing a Bluetooth Socket Scanner for Roam

  The programming barcodes shown below will only work with Socket Mobile brand Scanners. Set up your Socket Mobile scanner for iPad You can skip this step if using the socket scanner on an Android device 1. To turn the scanner on, press and hold the ...